« Driveway Lightning - John Dunn, Consultant, Ambertec, P.E., P.C. | Main | PWM Chip Slow CLK Fall Time - John Dunn, Consultant, Ambertec, P.E., P.C. »

September 22, 2011

Comments

Gerard Regnier

It's best to look at the final circuit in the frequency domain. You may be surprised at what you see as compared to what you thought you'd see when looking at the overall poles and zeros within a complex closed loop.

Frank Walker

Putting a low pass filter in the feedback path can cause problems, especially if the bandwidth is not sufficient to prevent overshooting (as seen in your graphic.)

Several reasonable alternatives exist:

1) Raise the bandwidth of the "low pass feedback filter" to be somewhat higher than the bandwidth of the opamp, at least enough so that the phase margin is not an issue.

This is likely best optimized by "knowing" what signal is to be rejected, or at least what the lowest possible frequency component to be rejected would be.

Since the only real purpose of the resistor is to decouple the opamp output from the capacitance, I would suggest using the absolute minimum value that accomplishes this goal. Again, keeping the Tau of the "low-pass feedback filter" sufficiently small to prevent phase issues.

2) Often it pays dividends to simplify the circuit, in this case I would suggest simply omitting the resistor and capacitor due to the fact the opamp is in a unity gain mode over the intended region of operation. Simply hook it up as a voltage follower and if necessary, place a "can" over the opamp to shield it from the EMI. (Obviously taking steps to reduce or eliminate the conducted EMI.)

Verify your Comment

Previewing your Comment

This is only a preview. Your comment has not yet been posted.

Working...
Your comment could not be posted. Error type:
Your comment has been saved. Comments are moderated and will not appear until approved by the author. Post another comment

The letters and numbers you entered did not match the image. Please try again.

As a final step before posting your comment, enter the letters and numbers you see in the image below. This prevents automated programs from posting comments.

Having trouble reading this image? View an alternate.

Working...

Post a comment

Comments are moderated, and will not appear until the author has approved them.

Your Information

(Name and email address are required. Email address will not be displayed with the comment.)

Editor

  Learn about our  

 free engineering 

consulting referral 

      service at:

 

  IEEE Consultant's 

      Network of 

     Long Island

 

We have over forty 

electrical, electronic, 

mechanical and 

software engineers 

with expertise in more 

than sixty-five categories 

of technology and business. 

All are members of the 

IEEE and adhere to the 

IEEE professional codes 

of ethics. 

No fee is charged for the

referral service. 

Each member is an 

independent consultant 

and negotiates his/her 

own consulting agreement.

 

Editor: Jerry Brown

Contributors:

John Dunn

Marty Kanner

Murray Kleiner

Dick LaRosa

David Pinkowitz

Carl Schwab

Gerry Bodner

Larry Rachman

 

Unless otherwise noted, 

reprinting or republication 

of anarticle on this blog is 

authorized by crediting the 

author and prominently 

displaying the following 

sentence at the beginning 

or end of the article,

including the hyperlink to

IEEE Consultant's Network 

of Long Island


"This report is republished 

with permission of IEEE 

Consultant's Network of 

Long Island"

 

Pages

Blog powered by Typepad

Enter your email address:

Delivered by FeedBurner